How to repair cracked vinyl siding
By Jakob Jelling
Although vinyl siding has many advantages over wood and does not wear as easily, sometimes it can be cracked and might have to be replaced. Extreme weather conditions, such as strong winds, can even pull vinyl siding out. As it can be seen, there are many reasons by which we might have to repair cracked vinyl siding, and knowing how to do it ourselves can save us not only money but also time when done correctly.
Before you start repairing cracked vinyl siding, you should make sure you have all the necessary tools and elements for it. You will need to have a backsaw, a "zip tool" to separate the panels, a carpenter's square, polyurethane caulking, a new section of vinyl siding, and a utility knife. If you have all this before you start, the work will be easier and faster.
In some cases, when the cracks are small, you might be able to easily fix them without needing to remove the section and replace it with a new one. In these cases, all you will need to do is patch the crack with silicone caulking compound. But, many of the times, the cracks are too big to be properly fixed with that procedure and you will have to replace the section.
In order to replace a section of vinyl siding, you will have to start by unfastening the panel with the zip tool. Start unfastening the section placed right where the vinyl siding is damaged and lift it. Once that panel is lifted, you will be able to remove the nails that hold the section you need to replace. Hold the section in place while removing the nails, and trace straight lines at its ends with the help of a square.
With the help of a utility knife, cut the panel following the lines you traced and remove the damaged section. Next measure that section and cut a 2 inches longer piece from the new section. This new section should overlap about 1 inch on each end. After this, you will be ready to fit it into place and nail it. Once you are sure it is firmly nailed, you should make the lifted upper panel go down again with the help of the zip tool.
About the Author
Get home design and decorating ideas by watching homes from all over the world - please visit http://www.dwank.com
Article Source: http://www.simplysearch4it.com/article/50074.html
|If you wish to add the above article to your website or newsletters then please include the "Article Source: http://www.simplysearch4it.com/article/50074.html" as shown above and make it hyperlinked.|
| Some other articles by Jakob Jelling|
|Mixing and pouring concrete|
Mixing and pouring concrete often sounds easier than it is. This task implies handling the right amount of ingredients and handling them at the right moment and the right ...
How to install replacement windows
Replacement windows can be a great choice when needing new windows and wishing to be able to replace them easily. Replacement ...
How to install an under-the-sink water filter
Installing a water filter can be very important, especially in those cases where water has more chlorine or minerals than we might ...
How to install a ceiling fan
A ceiling fan can be a great choice for acclimatizing an environment, especially when the space is reduced, but installing it can be difficult and tricky. ...
How to replace a windowsill
Replacing a windowsill can be easier than it seems, you might only need to count with the necessary tools and follow ...
How to install new wall covering
Installing new wall covering can cause a room to look completely different than before and can be a great way of renewing it ...