| |
How to install a wall to wall carpet
By Jakob Jelling
The first step in installing wall to wall carpet is going to be getting rid of the old carpet first. This is pretty easy, but make sure that you remove all of the moldings and take the door out of the doorway first. After you do this, vacuum the carpet to get as much dust up as possible. This will keep the air in your home cleaner while you work. Then, cut the carpetting into strips and then roll it up. This is the easiest way to transport the old carpet as well.
You will also need to make sure that you get rid of the underlay as well. Carpet is not dust, dirt, or waterproof, so most of what has been getting into the carpet or spilled onto it will also drip down into the underlay. As a result, you're probably best to change this while you change your carpet as well. Additionally, if there are wear patterns on your carpet from the places where people walk the most, then those patterns will probably also appear on the underlay.
After you take up the underlay, you should clean your subfloor. You can also take the time to make sure that all of your floorboards are nailed down correctly. Then, you'll need to put down your new tackless strips - which are what will keep your underlay in place, and finally, put down the new underlay.
There will probably be seams between the pieces of new underlay. If this is the case, then you should seal these seams off with duct tape. Then, you'll need to start laying your carpet. Since you want to lay wall-to-wall carpet, you need to start with a piece of carpet that is a few inches larger than the space you want to cover with carpet - you should have about 5 inches of extra carpet. Then, you'll just need to push the extra carpet down between the underlay and the wall. This will make sure that your carpet does not come up at the walls, or get pulled into the middle of the room through wear and tear.
If you have to connect any smaller pieces of carpet, then you'll have to do the seam in the same way. Make sure that your carpet is going to overlap by a few inches where you have that seam, and put a piece of adhesive down to make sure that the carpet pieces will stay together.
Finally, make sure that you use a knee kicker and a carpet stretcher to stretch the carpet over the tackless strips. This will attach your carpet firmly to the floor, and you'll be done! Now all you have to do is replace your door and moldings.
About the Author
Get home design and decorating ideas by watching homes from all over the world - please visit http://www.dwank.com
Article Source: http://www.simplysearch4it.com/author-articles/3689/1.html
| If you wish to add the above article to your website or newsletters then please include the "Article Source: http://www.simplysearch4it.com/author-articles/3689/1.html" as shown above and make it hyperlinked. |
| Some other articles by Jakob Jelling | How to clean a faucet aerator
Cleaning a faucet aerator is one of the most common basic tasks that need to be done now and then. The necessity of doing this becomes evident once some symptoms, such as weak water ...
How to install new wall covering
Installing new wall covering can cause a room to look completely different than before and can be a great way of renewing it without having to change the furniture or other decorative elements. When ...
How to install a dimmer switch
Installing a dimmer switch can allow you changing the mood of the room in a more important way than you might have imagined, and ...
How to replace a windowsill
Replacing a windowsill can be easier than it seems, you might only need to count with the necessary tools and follow several steps. We will provide you ...
How to install a ceiling fan
A ceiling fan can be a great choice for acclimatizing an environment, especially when the space is reduced, but installing it can be difficult and tricky. If you have a ceiling ...
How to repair cracked vinyl siding
Although vinyl siding has many advantages over wood and does not wear as easily, sometimes it can be cracked and might have to ...
|
|
| |
|
